best one for racing safe certification. good quality
inside have 3 model taka safeb let. you can see the picture to choose which one you like.
and we also have normal 4 point safe blet.
| | Short Eyebolt (4 provided with harness) | | Shoulder Pads |
| | Long Eyebolt | | Mounting Bracket |
| | 5 Point Crotch Strap | | 6 Point Crotch Strap |
step 1
Remove original bolt attaching seatbelt on driver side. Replace original bolt with eyebolt provided by Takta. Eyebolt should be facing seat. TAK
WARNING: Do not remove original seatbelts.
| | | |
step 2
Remove original bolt attaching seatbelt buckle on console side. Replace original bolt with eyebolt provided by . Eyebolt should be facing seat. WARNING: Do not remove original seatbelt buckle.
step 3Secure eyebolts for the shoulder belt attachment to (a) roll bar or (b) frame/body of car. If securing to frame/body of car, take precautions to ensure that location of eyebolt attachment is sufficiently reinforced to provide adequate strength at anchor point. If attaching to roll bar, make sure that proper attachment techniques are used. This would involve a wrapping technique. Ta long eyebolt may be required for this installation method.
Note: Use of reinforced steel mounting bracket to provide sufficient strength for anchor point. The Tak Mounting
Bracket can be used as well. Here, a piece of hard steel was cut and drilled to provide added strength for installation.
A lock washer, nut, and steel plate secure the long eyebolt in place.
step 4Thread Taka harness shoulder belts through seat as shown. Do not cross belts behind seat. Belts should pass through inner portion of headrest or be threaded through openings in seat if openings are available.
step 5Attach tongues of harness to eyebolts as shown, making sure that fasteners are in closed position when installed. Check angle of installation and position of shoulder belts to make sure position is within recommended limits.
Repeat for console side
If a roll bar is used, tongue attachments will differ from photos.
Check angle of installation and position of belts to make sure position is within recommended limits.
step 6Adjust belts to fit properly when seated. Belts should be free and clear of any potential snags, should not encumber the neck, and should not twist when worn.
.
this product is good quantity ,if you make a order, pls make aconfrim for it. thanks
